before we got a final display board from Unitec, we determined to buy a one by ourselves first in order to get better design. After project calss, we again together went to Tony's workshop. Tiitii's task was to put all the EFI components nicely and logically on the board which we just bought from Bunnies warehouse. then make all the measurements we need for our final board.
this is the picture we took after Tiitii finished the drawing, we will basically design our project on this blueprint.
all i have to do was to solder the speed motor control unit which i have nerver done that before. the lucky thing is that Tony knows it and i asked him some technical questions then got started. it was fun at the beginning, however it really piss you off after a few try. it took me five hours to finally get it done. but i don't know if it will work, but we will know once we use it.
the printed borad for speed motor control before i work on it
after i finised the soldering, ugly is not it?
about Tiitii's board design, we have to discuss all the time to decide which way to put the components is the best. after we came to a final decision, we took some pictures as a part of our project. next week is the time to sign the contract with our supervise. once we get his satisfaction, we can really start to do our project. our project.
we used one of the sides of the board to arrange the components so we can decide the best way to put them.
No comments:
Post a Comment